1. Take two pieces of
18ga wire approx. 20cm long, and form swirls at both ends of each
wire (start the swirls off with round nose pliers, then continue them
with flat nose pliers).
2. Connect the two
wires togetehr at one end near the swirls by wrapping the 24ga wire
around 5 or 6 times, then start adding beads.
3. Add just enough
beads to fill each section of the cuff, you will add more (or larger
beads) as you reach the middle. Between each section of beads, wrap
approx 8-10 times.
4. Once you've reached
the end, finish off by wrapping around both wires 5 or 6 times. Trim
the extra wire at both ends and flatten slightly with flat nose